Crushing Equipment
ZhengZhou YiFan Machinery Co.,Ltd.We provides crushing equipment for customers,which includes Sand Maker, Mobile Crusher... +86-371-64628852
E-mail: yifanseo@yfmac.com
Crushing Equipment
Homepage : News > How to use Sand MakerHow to use Sand Maker
Favorites / 
Print / 
The third generation sand maker is commonly used in crushing equipment, and various stone, tailings, and a variety of construction waste can be broken to 0-5MM, sand maker typically, a fixed job, therefore sand maker in the time of installation to be installed on the resource-rich places.
How to use sand maker:
1. sand maker is a stationary device, before installation, it should be the foundation to do a solid job.
2. sand maker after fastening to check the ministries fasteners installed in the device, if loose to be tighten. The same time to check the belt tightness is appropriate.
3. Before the start of the sand maker, the first rotation of the rotor by hand to check the tooth claw hammer and rotor operation is flexible and reliable, whether the shell collision phenomenon referred to in the same direction, the power machine and the mechanical direction of rotation of the rotor with the machine arrowlubrication is good.
4. Do not replace the pulley to prevent the excessive speed of the grinding chamber to produce an explosion, or speed too low to affect the work efficiency of the third generation sand maker.
5. After starting the third generation sand maker should first idling 2 ~ 3min, no anomalies after the feeding.
6. Work, we should always pay attention to the functioning of the third-generation sand maker, the feed should be uniform to prevent blocked stuffy car, not a long work overload. If it is found that vibration, noise, bearing the body temperature is too high, out spray material and so on, should be shut down immediately check troubleshooting before they can continue to work.
TOP
